How to step on the accelerator

The technique of stepping on the accelerator of a CVS was mainly reflected in the three aspects of starting, shifting gears, and overtaking. When starting, step on the accelerator slowly, and control the accelerator travel to about a quarter. This can avoid accidents caused by the sudden rush of the vehicle due to excessive accelerator. When shifting gears, if you want to use the accelerator to upshift, you can slowly lift the accelerator when the speed reaches about 2000 revolutions per minute, and the car's computer system will default to upshift. When overtaking, the car needs a large amount of torgue. If it is in a high-end and low-speed state, you can use the manual mode to downshift first, and then refuel to overtake. The novel " Watching the Moon on Fish Island " is equally exciting. Everyone is welcome to click and read it!

The technique of stepping on the accelerator of the CZT transmission was mainly reflected in the following three aspects: 1. When starting, step on the accelerator lightly, step on the accelerator for about a quarter of the total travel, so as to prevent the vehicle from suddenly rushing out and ensure a smooth and safe start. 2. When shifting gears: If you want to use the accelerator to shift up, slowly lift the accelerator when the car's speed reaches about 2000 revolutions per minute. The car's computer system will default to the upshift operation to achieve a smooth shift. 3. When overtaking: If the vehicle is in a high gear and low speed state, it is recommended to first lower the gear through manual mode, and then step on the accelerator to overtake the vehicle to ensure that the vehicle has enough power to complete the overtaking quickly and safely. The novel "Watching the Moon on Fish Island" is equally exciting. Everyone is welcome to click and read it!

If it was a partial CTV transmission with a hydraulic moment, it might go off without adding the accelerator after releasing the brake in D gear because the transmission characteristics of the hydraulic moment could allow it to release the brake and go. However, if it was on a slope, they might not be able to move forward without stepping on the accelerator. When the slope was steep, they might even retreat. This was because when the accelerator was not stepped on, the vehicle would be idling, which was equivalent to a neutral position and would not produce acceleration. The novel " Watching the Moon on Fish Island " is equally exciting. Everyone is welcome to click and read it!

When driving a vehicle equipped with a CVS transmission, it was not good to step on the accelerator and release it. The design principle of CVs was completely different from other transmissions. It used steel belts to transmit energy and had no gear logic. The driving computer would automatically adjust the speed ratio no matter how much the accelerator was stepped on. If the accelerator was stepped on and loosened, the driving computer would frequently change the instructions. This kind of operation was not good for the car and would only make the car consume more fuel. The novel " Watching the Moon on Fish Island " is equally exciting. Everyone is welcome to click and read it!

The strange sound of the transmission could be caused by many reasons. When the accelerator was stepped on in winter, the transmission made a cracking sound. It might be due to the poor mobility of the transmission oil in the low temperature environment, the reduction of anti-wear performance and smoothness, resulting in the wear or damage of bearings, gears and other components; It could also be caused by the wear and tear of bearings, the wear and tear of transmission parts or the low precision of the parts selected during replacement, insufficient or excessive wear and tear of the grease leading to poor smoothness, loosening of the bolts of the transmission casing (end cover), etc. If the transmission makes continuous high-frequency metal friction sound, it is usually due to the loss or deterioration of gear oil. The noise can be eliminated by adding oil or changing oil. If the neutral position is abnormal and the abnormal sound disappears when the clutch is stepped on, it may be a problem with the clutch. You can lift the transmission to check the clutch. If all the gears have abnormal noise, it is usually the rear bearing of the transmission output shaft. You need to disassemble the transmission and check the bearing condition. If the abnormal sound of the direct gear disappears and there are abnormal sounds in other gears, it means that the front bearing of the second shaft or the intermediate shaft bearing is damaged. Open the transmission to check the condition of the intermediate shaft. If a high-frequency abnormal sound occurs continuously in a certain gear during driving, it is usually the metal on the gear surface is worn and peeled off. In serious cases, it is necessary to change gears. If it was a periodic noise, it was most likely a broken tooth. They should stop to check the transmission first. If it was serious, they should let the trailer tow the car to the repair shop to avoid further damage. The novel "Watching the Moon on Fish Island" is equally exciting. Everyone is welcome to click and read it!

Stepping on the accelerator didn't necessarily cause the CVS to break down, but there was a risk of damaging the vehicle. The CTV was a continuously variable transmission that relied on a steel belt to drive between two compressed cone wheels. If the accelerator was stepped on deeply, the engine would increase the speed of the main wheel in a short period of time, and the steel belt would increase wear and tear, resulting in a shorter service life. Stepping on the accelerator for a long time would bring a large load to the CVS, affecting the transmission. It might also destroy the static friction between the steel belt and the cone wheel, resulting in sliding friction, which would cause scratches and wear on the cone wheel and the steel belt. In serious cases, it would cause faults such as steel belt fracture and anchor. In addition, when the temperature of the vehicle was low, the oil did not reach the best working condition, and most of it was in a solidified state. At this time, stepping on the accelerator would cause the transmission to shift abnormally, which would reduce the service life of the transmission for a long time. At the same time, long-term violent driving on the accelerator may also cause the car to burn oil. In serious cases, the temperature of the brake pads will rise, the braking ability will be reduced, and even problems such as cylinder pulling and cylinder explosion will occur. However, if the engine and transmission were reasonably matched in the early stages of development, so that the maximum load of the transmission was greater than the maximum output of the engine and a certain safety margin was retained, then the CTV transmission would not be easily damaged if the accelerator was stepped on to a certain extent (for example, within 3000 - 4000 revolutions and there was no transmission fault alarm on the instrument). The novel "Watching the Moon on Fish Island" is equally exciting. Everyone is welcome to click and read it!

During the driving process, if he kept stepping on the accelerator, the power of the self-suction engine would not increase, but would instead decrease. If he wanted to increase the power, he could step on the accelerator and then release it. Then, he stepped on the accelerator and landed on the previous position. He could clearly feel the engine's power increase. The principle of this operation method was that when the accelerator was suddenly released, the driving computer would detect that the owner was simulating manual gear and preparing to change gears (it could be simulated according to the principle of manual transmission), so the transmission began to downshift. When the accelerator was stepped on again, the transmission began to increase from low gear to high gear, and the power would increase. However, this method of operation was more suitable for CVs. It was uncertain if this method could be used for dual clutch transmissions and AT transmissions. Moreover, this method was more difficult to control for beginners. When the novice released the accelerator and stepped on it, because the speed was slowly increased before, it would be dangerous because the depth of the accelerator was not controlled well. Even if the danger was avoided, it would make the passengers in the car feel uncomfortable. The novel "Watching the Moon on Fish Island" is equally exciting. Everyone is welcome to click and read it!

For CVs, it was reasonable to say that stepping on and releasing the accelerator would speed up the car. When the vehicle's accelerator was released and stepped on again, the driving computer would determine that the owner wanted to overtake and increase the vehicle's power. The vehicle would downshift, increase the engine speed, and the engine's torque-burst would release more power. However, the CVS transmission was not made for intense driving. It pursued reliability, durability, and fuel rationality. Therefore, even if stepping on the accelerator would make the vehicle speed up relatively faster, the CVS transmission as a whole was not suitable for intense driving. Moreover, this operation may vary according to the specific conditions of the vehicle. The novel " Watching the Moon on Fish Island " is equally exciting. Everyone is welcome to click and read it!

When the left front wheel stepped on the accelerator at a low speed, it made a clicking sound, which could be caused by the following reasons: 1. The suspension gap of the left front wheel increased. 2. The left front wheel's shock bumper had malfunctioned. 3. The steering ball head or the suspension of the undercarriage were aging. 4. If the sound was rhythmic and the faster the car was, the faster the sound would be, then there might be foreign objects on the tires, such as stones or nails. 5. If there was a similar sound when turning, crossing, or walking on a bad road, it might be the outer ball cage of the left front half shaft, the shock Absorber was broken, or the ball head and bushing of the chassis suspension were worn out. If this happens, it is recommended to go to a professional car repair shop for inspection as soon as possible. The novel " Watching the Moon on Fish Island " is equally exciting. Everyone is welcome to click and read it!